|
Post by roadrunner on Jan 24, 2010 20:19:10 GMT -5
ok so i got one piece headlights for my teg for christmas and got 9007 bulbs for my bday for them..
once you've got them installed you have to swap 2 wires dependin on what harness you swap depends on the wires..
option a. you can swap on your stock harness where the new and old harness connect .. if you choose to swap those you can either cut or pull the left and middle wire out and swap if you pull there is a little metal bracket like thing you have to hold down and the wires should slip right out and thenyou can swap and slip in just as easy or if you choose to cut to so but make sure to leave yourself room to strip some wiring cover off and sodder/ heat shrink wrap or electrical tap can be used to reattach the wires
option b. you can swap on your headlight harness which is what i did.. if yo choose to do so you must swap the right and middle wires these im not sure will pull out of the housing so i would recommend just cuttin and using the same method above to reattach the wires.
once you've got them lookin bright make sure to adjust your light height there are 2 aiming screws on each housing that aim you beam up and down and then left to right
thats what ive done so far i'll post pics when i get some and good luck to anyone that tires this!
|
|